GARAGE DOOR TORSION SPRING CALCULATOR INSTALL THE CABLE

The average residential spring cycle is designed for 10,000 cycles (up and down is one cycle), so depending on how often the garage door is used will determine how long the spring will last.Torsion Spring Calculator. Torsion springs have the same concept. EZ-SET Torsion Spring System - Menards EZ-SET Torsion Spring System Assembly Installation Instructions'&'()+(,'-)+.'' /012'3.With any steel, the more you bend it the weaker it becomes. Prime-Line GD 52238 Torsion Spring Winding Rods The Only Tools Recommended for Adjusting or Replacing Garage Door Tension Springs 1/2 Diameter x 16 Long Round Steel Rods (Pack of 2) 4.7 out of 5. X 20 in., Orange, Right Hand Wind. Prime-Line Products GD 12315 Garage Door Torsion Spring.

To determine the wind of the spring, if the wind of the spring points in the counterВ clockwise direction, that means it is a left wound spring, this is not what side the spring goes on the door it is only to determine which way the spring is wound. To measure the correct diameter, count 20 coils and then measure. The next step to measuring the wire diameter, is the thickness of the coil. The inside diameter is measured from the end of the spring, and can also be measured with a caliper or a tape measure or could also be stamped on the spring fitting. If the torsion spring is broken measure the spring in its entirety.

With a winding bar insert it into the bottom hole of the winding cone (the cone attached to the spring) of the good spring. Start by locking the garage door so it cannot come up and hit you while you are winding the new springs. The first step is to unplug the opener, so no one can try to open the garage door while you are changing the springs. Always be sure to match the wind of the spring to the existing springs to ensure they are put back on correctly.Caution a Garage door torsion spring is under a great amount of tension and require appropriate safety precautions.When it comes to replacing the garage door torsion springs, make sure to have the correct tools to replace the torsion spring, for example the winding bars. Right wound spring would mean it is wound clockwise.

Next, loosen the set screws on both the left and the right drums, then lift the cable drums and disconnect the lift cables. Then, secure the torsion tube (the meatal tube that holds the torsion springs) to do so place locking pliers on the center bracket to hold the torsion tube in place. The next step will be to disconnect the springs from the center bracket, remove the two nuts and bolts that hold the cone to the center bracket, and move the spring towards the end brackets. When unwinding the broken spring, you want to leapfrog the winding bars. To unwind the broken spring insert the second winding bar in the 9:00 position, then remove the first (bottom) winding bar and unwind the broken spring a quarter turn at a time.

Garage Door Torsion Spring Calculator Install The Cable

When tightening the drums snap locking pliers to hold the torsion tube in place. Reinstall the cable drum, and re insert the torsion bar in to the left side bearing bracket. Slide the new spring on to the torsion tube with the cone facing the center bracket for the left spring.

If the door stays in place the torsion springs are adjusted correctly, however if it falls then you should add three quarter turn to each spring. Tighten the set screws and extra one half to 3 quarter turn.Slide a piece of cardboard between the wall and the springs, saturate the springs with garage door lubricant and wipe off the access.Remove the clamps or pliers from the torsion tube and the track, lift the door about 3ft off the ground by hand and let go. Then tighten the set screws until they make contact with the torsion tube, be sure not to tighten them too tight or it will damage the torsion tube.